書誌事項
- タイトル別名
-
- Proposal and Verification of New Concept Rolling Mill Realizing<br>Real-Time Estimation and Control of Roll Force Distribution
- アツエン カジュウ ブンプ ノ リアルタイム スイテイ セイギョ オ ジツゲン スル シン ケイシキ アツエンキ ノ テイアン ト ゲンリ ケンショウ シン ケイシキ チノウ アツエンキ ノ カイハツ ダイ1ポウ
- — Development of NSC Intelligent Mill I —
- — 新型式知能圧延機の開発 第１報 —
この論文をさがす
抄録
A new concept rolling mill for flat products, i.e. the NSC intelligent mill (NIM), has been proposed. The NIM concept states that the mill can estimate and control roll force distribution across the width between the work roll and the rolled material during rolling. The roll force distribution reflects longitudinal stress distribution in the rolled material, which has a direct relationship with the flatness of the rolled material. Hence, the NIM enables real-time flatness detection and control, and the NIM can eliminate the limitations of conventional flatness control technology as follows: delay of control response mainly due to transport time from the rolling mill to the flatness sensor, noncontrol portion of the head end of the rolled material, and limited flatness control accuracy due to the low accuracy of the flatness sensor. A pilot mill on the laboratory scale was constructed, and the concept of NIM, as well as feasibility of the real-time estimation of roll force distribution, was verified.
収録刊行物
-
- 塑性と加工
-
塑性と加工 52 (609), 1094-1098, 2011
一般社団法人 日本塑性加工学会
- Tweet
キーワード
詳細情報 詳細情報について
-
- CRID
- 1390282681475420672
-
- NII論文ID
- 130004787319
- 10029483825
-
- NII書誌ID
- AN00135062
-
- ISSN
- 18820166
- 00381586
-
- NDL書誌ID
- 11289169
-
- 本文言語コード
- ja
-
- データソース種別
-
- JaLC
- NDL
- Crossref
- CiNii Articles
-
- 抄録ライセンスフラグ
- 使用不可