Effect of Welding Conditions on Reduction of Angular Distortion by In-Process Control Welding using Back Heating Source

この論文にアクセスする

この論文をさがす

著者

    • OKANO Shigetaka
    • Division of Materials and Manufacturing Science, Graduate School of Engineering, Osaka University
    • MOCHIZUKI Masahito
    • Division of Materials and Manufacturing Science, Graduate School of Engineering, Osaka University
    • TOYODA Masao
    • Division of Materials and Manufacturing Science, Graduate School of Engineering, Osaka University

抄録

In order to investigate the effect of welding conditions on reduction of angular distortion by in-process control welding using back heating source, numerical analysis is done. Furthermore, positional condition setting of back heating source and required back heat input for complete control of residual angular distortion are discussed. These results show that in-process control welding by back heating immediately behind of welding torch can be extremely effective to reduce angular distortion.

収録刊行物

  • 溶接学会論文集 : quarterly journal of the Japan Welding Society

    溶接学会論文集 : quarterly journal of the Japan Welding Society 27(2), 231s-234s, 2010-01-20

    一般社団法人 溶接学会

参考文献:  4件中 1-4件 を表示

被引用文献:  1件中 1-1件 を表示

各種コード

  • NII論文ID(NAID)
    10030149247
  • NII書誌ID(NCID)
    AN1005067X
  • 本文言語コード
    ENG
  • 資料種別
    ART
  • ISSN
    02884771
  • データ提供元
    CJP書誌  CJP引用  J-STAGE 
ページトップへ