Evaluation of Residual Stress Distribution in Austenitic Stainless Steel Pipe Butt-Welded Joint

この論文にアクセスする

この論文をさがす

著者

抄録

This paper reports measured and estimated results of residual stress distributions of butt-welded austenitic stainless steel pipe in order to improve estimation accuracy of welding residual stress. Neutron diffraction and strain gauge method were employed for the measurement of the welding residual stress and its detailed distributions on inner and outer surface of the pipe as well as the distributions within the pipe wall were obtained. Finite element method was employed for the estimation. Transient and residual stresses in 3D butt-welded joint model were computed by employing Iterative Substructure Method and also commercial FEM code ABAQUS for a reference. The measured and estimated distributions presented typical characteristic of straight butt-welded pipe which had decreasing trend along the axial direction and bending type distributions through wall of the pipe. Both results were compared and the accuracy of measurement and estimation was discussed.

収録刊行物

  • 溶接学会論文集 : quarterly journal of the Japan Welding Society

    溶接学会論文集 : quarterly journal of the Japan Welding Society 27(2), 240s-244s, 2010-01-20

    JAPAN WELDING SOCIETY

参考文献:  5件中 1-5件 を表示

各種コード

  • NII論文ID(NAID)
    10030149258
  • NII書誌ID(NCID)
    AN1005067X
  • 本文言語コード
    ENG
  • 資料種別
    ART
  • ISSN
    02884771
  • データ提供元
    CJP書誌  J-STAGE 
ページトップへ