回転プローブによる工業用純チタンとアルミニウム合金の固相接合 Solid State Welding of CPTi and Aluminum Alloy Using a Rotating Probe

この論文にアクセスする

この論文をさがす

著者

抄録

Authors tried to butt-joint weld commercially pure titanium plate to aluminum alloy plate by solid state welding using a rotating probe, and investigated the effects of welding conditions and intermetallic compound formed at the weld interface on the properties of the joint. The following results were obtained.<br>The titanium plate and the aluminum alloy plate were successfully butt-joint welded using a rotating probe. The tensile strength of the joint made under the optimum conditions was so high that the joint efficiency was about 97%.<br>The joint strength varied with the probe rotation speed and the offset. Fracture of the joint made under the optimum conditions occurred at the position in aluminum alloy, where the hardness was lower, 5–7mm away from the weld interface as well as at the interface between aluminum matrix and titanium fragments which were scattered around the weld interface.<br>By heating at 550°C for 2h, intermetallic compound obviously appeared at the weld interface of the joint made under the optimum conditions. Fracture of the heated joint occurred at the weld interface, and the tensile strength and the elongation extremely decreased.

収録刊行物

  • 溶接学会論文集 : quarterly journal of the Japan Welding Society

    溶接学会論文集 : quarterly journal of the Japan Welding Society 28(2), 255-260, 2010-12-31

    一般社団法人 溶接学会

参考文献:  21件中 1-21件 を表示

各種コード

  • NII論文ID(NAID)
    10030150109
  • NII書誌ID(NCID)
    AN1005067X
  • 本文言語コード
    JPN
  • 資料種別
    ART
  • ISSN
    02884771
  • データ提供元
    CJP書誌  J-STAGE 
ページトップへ