低融点銀ろうによる超硬合金のろう付 Brazing of Cemented Carbide Using Ag-based Filler Metals with a Low Melting Point

この論文にアクセスする

この論文をさがす

著者

抄録

The present study was aimed at producing new Ag-based filler metals that have a melting point lower than that of a conventional Ag-based filler metal (BAg-24) for brazing cemented carbide and possess the ability to provide a high strength joint of cemented carbide. Using an Ag-based filler metal with a lower melting point (BAg0) that was a quaternary alloy of Ag-Cu-Zn-Sn system previously developed by authors, and Ag-based filler metals with Ni or Co element added into the BAg0, cemented carbide rods were brazed. Bending strength of the joint and the brazed layer microstructure were investigated. The following results were obtained in this study.<br>Bending strength of a joint brazed at 650°C using the BAg0 was about 85% that of a joint brazed at 750°C using the BAg-24. When Ni element was added into the BAg0, intermetallic compounds were formed in the brazed layer, and bending strength of a brazed joint was decreased. By adding a small amount of Co element into the BAg0, bending strength of a joint brazed at 650°C was improved and was equivalent to that of a joint brazed at 750°C using the BAg-24. However, excessive addition of the Co element made the bending strength of a joint decreased.

収録刊行物

  • 溶接学会論文集 : quarterly journal of the Japan Welding Society

    溶接学会論文集 : quarterly journal of the Japan Welding Society 29(3), 204-209, 2011-12-31

    一般社団法人 溶接学会

参考文献:  9件中 1-9件 を表示

各種コード

  • NII論文ID(NAID)
    10030150941
  • NII書誌ID(NCID)
    AN1005067X
  • 本文言語コード
    JPN
  • 資料種別
    ART
  • ISSN
    02884771
  • データ提供元
    CJP書誌  J-STAGE 
ページトップへ