Fabrication of Micro Patterned Ceramic Structure by Imprinting Process (特集 多様化する粉体成形の新しい展開) Fabrication of Micro Patterned Ceramic Structure by Imprinting Process

この論文にアクセスする

この論文をさがす

著者

抄録

In this report, an improved fabrication method of micro powder imprinting (μPI), which has the industrial value in reducing of the cost and procedures, is introduced to fabricate the thin yttria-stabilized zirconia (YSZ) sheet with the micrometer scale patterns. The Kapton film mold was designed and employed in thermal imprinting in order to prevent the breakage of sheet as mold removing. After imprinting, debinding and sintering procedures, the well pattern consistence line and space patterns in scale of 8 μm were obtained on 300 μm thick ceramic sheets. The morphology of sintered ceramic patterns was observed and the behaviors of debinding and sintering were investigated in this report. Meanwhile, the imprinting on bilayer ceramic sheet was carried out and the results showed the well wave interface of each layer, which have the potential utilization for solid oxide fuel cell directly.

収録刊行物

  • 粉体および粉末冶金

    粉体および粉末冶金 58(11), 673-678, 2011-11-15

    一般社団法人 粉体粉末冶金協会

参考文献:  24件中 1-24件 を表示

被引用文献:  1件中 1-1件 を表示

  • 粉末成形

    粉体加工成形プロセス分科会 , 徳岡 輝和

    塑性と加工 53(619), 710-711, 2012-08-25

    J-STAGE 参考文献26件

各種コード

  • NII論文ID(NAID)
    10030479483
  • NII書誌ID(NCID)
    AN00222724
  • 本文言語コード
    ENG
  • 資料種別
    ART
  • ISSN
    05328799
  • NDL 記事登録ID
    023350089
  • NDL 請求記号
    Z17-274
  • データ提供元
    CJP書誌  CJP引用  NDL  J-STAGE 
ページトップへ