Feasible Study for Multi-photon Stereolithography Method of Electro Conductive Polymer Actuator with Complex Shape
-
- Sone Junji
- Faculty of Engineering, Tokyo Polytechnic University
-
- Asami Akihisa
- Faculty of Engineering, Tokyo Polytechnic University
-
- Yamada Katsumi
- Faculty of Engineering, Tokyo Polytechnic University
-
- Chen Jun
- Faculty of Engineering, Tokyo Polytechnic University
この論文をさがす
抄録
Recently, a soft actuator was developed using an electro-conducting polymer and an ionic conducting polymer. Moreover, stereolithography that uses a femtosecond laser was researched as a method of multiphoton-sensitized polymerization. In this study, we tried a more stable and more rapid stereolithography method for fabricating an electro-conducting polymer using a protein material. From the results of this study, we found that the method was 10 times faster when an aqueous solid that included an electro-conducting polymer, a catalyst, and gelatine was used. In addition, it was stable in that the temperature of the aqueous solid was controlled at 10 degree. We built a 3D shape using the newly developed method, and we will apply this method to a complex actuator.
収録刊行物
-
- 電気学会論文誌E(センサ・マイクロマシン部門誌)
-
電気学会論文誌E(センサ・マイクロマシン部門誌) 132 (5), 139-140, 2012
一般社団法人 電気学会
- Tweet
詳細情報 詳細情報について
-
- CRID
- 1390282679438954496
-
- NII論文ID
- 10030607158
-
- NII書誌ID
- AN1052634X
-
- BIBCODE
- 2012IJTSM.132..139S
-
- ISSN
- 13475525
- 13418939
-
- 本文言語コード
- en
-
- データソース種別
-
- JaLC
- Crossref
- CiNii Articles
-
- 抄録ライセンスフラグ
- 使用不可