代表的な自動車用焼結鋼の引張および圧縮耐力の検討 Investigation of Tensile-Compressive Poof Strength of Representative PM Steels for Automotive Applications

この論文にアクセスする

この論文をさがす

著者

抄録

A sintered part for automobile has been growing so far. Also, demands for higher strength of the materials are increasing. The compressive strength becomes more important in their requirement. However there are few detailed studies on compressive properties of sintering materials. Generally, it is thought that it was considered compression and tensile proof stress equal in strength of materials. It is important that compressive properties are measured precisely from the situation of the design. This study investigated the compression properties and simulated it about the stress behavior of sintering materials. In this examination, all sintered test pieces showed higher compressive proof strength than tensile proof strength. And the simulation, in elastic level, supported these results.

A sintered part for automobile has been growing so far. Also, demands for higher strength of the materials are increasing. The compressive strength becomes more important in their requirement. However there are few detailed studies on compressive properties of sintering materials. Generally, it is thought that it was considered compression and tensile proof stress equal in strength of materials. It is important that compressive properties are measured precisely from the situation of the design. This study investigated the compression properties and simulated it about the stress behavior of sintering materials. In this examination, all sintered test pieces showed higher compressive proof strength than tensile proof strength. And the simulation, in elastic level, supported these results.

収録刊行物

  • 粉体および粉末冶金

    粉体および粉末冶金 59(5), 254-257, 2012-05-15

    Japan Society of Powder and Powder Metallurgy

参考文献:  3件中 1-3件 を表示

被引用文献:  1件中 1-1件 を表示

  • 粉末成形

    三浦 秀士 , 沖本 邦郎 , 宇波 繁 , 渡辺 龍三 , 後藤 隆宏 , 近藤 勝義 , 三浦 秀士 , 品川 一成 , 高木 研一 , 松原 秀彰 , 川崎 亮 , 橋井 光弥 , 久米 裕二 , 徳岡 輝和 , 三浦 秀士 , 津守 不二夫

    塑性と加工 54(631), 703-706, 2013-08-25

    J-STAGE 参考文献81件

各種コード

  • NII論文ID(NAID)
    10030765108
  • NII書誌ID(NCID)
    AN00222724
  • 本文言語コード
    JPN
  • 資料種別
    ART
  • ISSN
    05328799
  • NDL 記事登録ID
    023804818
  • NDL 請求記号
    Z17-274
  • データ提供元
    CJP書誌  CJP引用  NDL  J-STAGE 
ページトップへ