Hydrostatic pressure and fluid density profile in deep ice bore-holes

Search this Article

Author(s)

Abstract

The drilling of deep bore-holes in ice requires that the hole is filled by a liquid to compensate the ice-overburden pressure. Moreover, the hydrostatic pressure of the fluid should be exactly known in order to estimate the hole closure. The estimation of the hydrostatic pressure in the bore-hole can be made in two different ways. The first is the in situ measurements using pressure sensor, and the second is calculation of the pressure using the sampling of drilling fluid from different depths. The second method can be used also for prognosis of the hydrostatic pressure when the necessary density of the hole liquid is chosen. The paper includes the necessary equations for the calculation of hydrostatic pressure for one and two-compound liquids based on the pressure and temperature in the bore-hole. The measured and calculated densities are compared for the GISP2 bore-hole at Summit, Greenland, and it shows a high correlation. The difference between measured pressure and calculated pressure along most of the hole length doesn't exceed 0.12%.

Journal

  • Memoirs of National Institute of Polar Research. Special issue

    Memoirs of National Institute of Polar Research. Special issue 56, 171-180, 2002-03

    National Institute of Polar Research

Codes

  • NII Article ID (NAID)
    110000010504
  • NII NACSIS-CAT ID (NCID)
    AA00733561
  • Text Lang
    ENG
  • ISSN
    03860744
  • Data Source
    NII-ELS 
Page Top