揺動速度制御型連続研削・研磨装置の開発（第2報）

DOI Web Site 被引用文献2件 参考文献6件

書誌事項

タイトル別名
  • Development of Oscillation-Speed-Control-Type Sequential Grinding and Polishing Machine (2nd Report)
  • 揺動速度制御型連続研削・研磨装置の開発(第2報)研削による軸対称形状創成と揺動速度制御研磨による形状修正
  • ヨウドウ ソクド セイギョガタ レンゾク ケンサク ケンマ ソウチ ノ カイハツ ダイ2ホウ ケンサク ニ ヨル ジク タイショウ ケイジョウ ソウセイ ト ヨウドウ ソクド セイギョ ケンマ ニ ヨル ケイジョウ シュウセイ
  • -Creation of Grinding Profile with Axial Symmetry and Polishing Profile Planarized by Oscillation Speed Control-
  • －研削による軸対称形状創成と揺動速度制御研磨による形状修正－

この論文をさがす

抄録

An oscillation-speed-control-type sequential grinding and polishing machine has been developed to achieve a site flatness better than 90nm per 25-mm square except for 2mm adjacent to the edge of a 12-inch silicon wafer. The machine allows a wafer to be polished after grinding without removal from the machine. This paper describes the creation of a grinding profile, a solution to the problem of flatness degradation, and the optimum polishing conditions to obtain good flatness. The moving path of the grinding wheel is accurately transferred to the ground wafer surface except its center portion, where the profile becomes concave due to high cutting path density of the grinding wheel. Good flatness was achieved with a simple inclination adjustment method that involves hanging a weight from the grinding head or using a very low infeed rate to decrease the grinding force. The ground wafer was polished at the optimum oscillation speed and a super-high flatness of less than 0.1µm over the entire surface was achieved. In addition, this result was roughly consistent with the simulation result.

収録刊行物

被引用文献 (2)*注記

もっと見る

参考文献 (6)*注記

もっと見る

キーワード

詳細情報 詳細情報について

問題の指摘

ページトップへ