造塊用粘土質耐火煉瓦の諸性質と熱的スポーリング抵抗性に関する考察

DOI Web Site Web Site

書誌事項

タイトル別名
  • On the Physical-Mechanical Properties and the Thermal Shock Resistance of Fire Clay Brick for Casting Pit
  • ゾウカイヨウ タイカブツ ニ カンスル ケンキュウ 2
  • Some Studies on the Fire Clay Refractories for Casting Pit, II
  • 造塊用耐火物に関する研究 (第2報)

この論文をさがす

抄録

For the purpose of investigating the effective way of preventing the thermal fracture of various bricks for bottom casting pit in teeming of molten steel, the equation of thermal shock resistance has been deduced from thermal stress equation, and the physical-mechanlcal properties of various bricks have been determined by testing. On the basis of the results obtained, considerations have been made concerning the effect of these properties and the size of each brick on thermal shock resistance.<br>Important results obtained are summarized as follows:<br>i) In the thermal stress equation σ=Eα/(1-μ)⋅(θ0-Θ)⋅f, thermal shock resistance (R) are expressed in σmax/σ′, putting σ′ as max. thermal stress in tension, f′ as factor f corresponding to σ′, σmax as max. tensile strength of a brick.<br>ii) Heat-transfer coefficient from molten steel flowing at temperature θ0 to the surface of the brick at temperature Θ being in contact with molten steel flow is very large, and therefore, thermal shock resistance is expressed by the following two equations.<br>In the earliest stage, when heat does'nt begin to flow within a brick:<br>R2′=σmax/E⋅(1-μ)/α⋅1/(θ0-Θ)<br>In the next stage, when heat flows within a brick:<br>R1′=σmax/E⋅(1-μ)/α⋅1/(θ0-Θ)⋅(kt1/2/γ)a<br>or R1′=σmax/E⋅(1-μ)/α⋅1/(θ0-Θ)⋅(K/γh)a′<br>iii) The relation between the mechanical properties and porosity may be expressed by a hyperbolic curve.<br>iv) The ratio of bending strength to Young's modulus, an effective factor for increasing thermal shock resistance, is larger in pyrophillite-clay brick than that in grog-clay brick. This ratio shows a trend to decrease with increasing porosity. It is presumed from the data in technical literatures that this ratio is approximately constant at high temperature below the critical temperature of pyroplastic property.<br>v) Based on the equation of thermal shock resistance determined in the case of runner brick, it is estimated that bending strength/Young's modulus ratio, linear thermal-expansion coefficient (α), poisson's ratio (μ) and temperature difference (θ0-Θ) have an influence of first power. On the other hand, the thermal conductivity (K), specific heat (Cρ), density (ρ) and wall thickness (γ) have an infiuence of 0.040 and 0.081 powers, respectively, on thermal shock resistance. In addition, considerations have been made concerning the degree of the effect of porosity, which is in functional relation to mechanical properties and thermal conductivity, on the thermal shock resistance.<br>vi) It is presumed that there is a limit in the improvement of thermal shock resistance by changing the properties of a fire clay brick and that most important factor for the prevention of thermal fracture is the moderate pyroplastic property.

収録刊行物

  • 窯業協會誌

    窯業協會誌 68 (780), 283-294, 1960

    公益社団法人 日本セラミックス協会

詳細情報 詳細情報について

問題の指摘

ページトップへ