この論文をさがす
抄録
In order to improve the quality of roll-finished involute helical gears, a calculation program for roll-finished tooth form has been developed, which can deal with tooth form correction of die-wheel and tooth form error of work-gear before roll-finishing. In this calculation, gradual changing of tooth form of work-gear with progress of plastic deformation is taken in consideration. Some comparisons between calculated and measured tooth forms of helical and spur gears roll-finished by die-wheels with and without die-profile correction under some roll-finishing conditions showed fairly good coincidence. This program can therefore help to decide the optimum tooth form of die-wheel and the optimum working condition.
収録刊行物
-
- Bulletin of JSME
-
Bulletin of JSME 23 (185), 1913-1920, 1980
一般社団法人 日本機械学会
- Tweet
キーワード
詳細情報 詳細情報について
-
- CRID
- 1390282681470203776
-
- NII論文ID
- 110002359402
-
- NII書誌ID
- AA0058509X
-
- ISSN
- 18811426
- 00213764
-
- 本文言語コード
- en
-
- データソース種別
-
- JaLC
- Crossref
- CiNii Articles
-
- 抄録ライセンスフラグ
- 使用不可