多軸ボールエンドミル加工における切取り厚さの理論解析

書誌事項

タイトル別名
  • Theoretical Analysis of Undeformed Chip Thickness for Multi-Axis Ball-Nosed End Milling.
  • タジク ボール エンド ミル カコウ ニ オケル キリトリ アツサ ノ リロン カイセキ

この論文をさがす

抄録

This paper presents a new analytical method to estimate the thickness of an undeformed chip in ball-nosed end milling. It has been firstly pointed out that the geometric situations on the determination of the thickness are categorized in three cases based on the relationship among the milling parameters. Secondly each corresponding case has been reduced into a comprehensive equation with introducing a coordinate system of tool axis orientation. Then the result of analysis has been displayed in 3D graphics. Through the analysis of the equations, it was found that the tool axis orientation had direct influence to the thickness of the undeformed chip. Besides the description of analytical solving procedures, some experiments of undeformed chip thickness have been shown and the brief conclusion has been mentioned too.

収録刊行物

被引用文献 (5)*注記

もっと見る

参考文献 (12)*注記

もっと見る

詳細情報

問題の指摘

ページトップへ