818 電極消耗を利用したマイクロ放電加工(マイクロ加工)(OS.1 生産加工・工作機械)

• 山崎 実

  都産技研

• 森 紀年

  都産技研

• 武井 健三郎

  電機大

• 國枝 正典

  農工大

書誌事項

タイトル別名

• 818 Micro-EDM of Tapered Holes and Rods utilizing Electorode-Wear

抄録

This paper discribes a new method for micro-EDM drilling which utilizes the wear of a rod electrode. In this method, the polality of the rod electrode is positive, and the rotating rod electrode is fed into the block electrode with a feed rate of several tens times higher than the normal one. Since the circumferential region of the rod electrode wears with a much higher rate than the central region, the end of the rod electrode is sharpened in a few minutes. At the same time, a cone-like micro-hole with sharp bottom shape is generated in the block electrode automatically.

収録刊行物

• 日本機械学会関東支部総会講演会講演論文集

  日本機械学会関東支部総会講演会講演論文集 2001.7 (0), 77-78, 2001

  一般社団法人 日本機械学会

キーワード

• Micro-EDM
• Micro-machining
• WEDG
• Tapered-hole
• Tapered-rod
• Electrode-Wear

詳細情報

• CRID: 1390001205847877888
• NII論文ID: 110002495992
• DOI: 10.1299/jsmekanto.2001.7.77
• ISSN: 24242691
• Web Site: https://www.jstage.jst.go.jp/article/jsmekanto/2001.7/0/2001.7_77/_pdf
• 本文言語コード: ja
• データソース種別:
  • JaLC
  • Crossref
  • CiNii Articles
• 抄録ライセンスフラグ: 使用不可