Low-Cost Hybrid WDM Module Consisting of a Spot-Size Converter Integrated Laser Diode and a Waveguide Photodiode on a PLC Platform for Access Network Systems

この論文をさがす

抄録

This paper describes the technological issues in achieving a low-cost hybrid WDM module for access network systems. The problems which should be resolved in developing a low-cost module are clarified from the viewpoint of the module assembly in mass production. A design concept for a low-cost module suitable for mass production is indicated, which simplifies the alignment between a laser diode and a waveguide, and reduces the number of the components such as lenses and mirrors. The low-cost module is achieved by employing a flip-chip bonding method with passive alignment using a spot-size converter integrated laser diode (SS-LD) and p-i-n waveguide photodiodes (WGPDs) on a planar lightwave circuit (PLC) platform. We confirm that the SS-LD and the WGPD provide high coupling efficiency with a large tolerance for passive alignment. To achieve a high-sensitivity receiver, the module is designed to employ an asymmetric PLC Y-splitter that prefers a PD responsivity to an LD output power because of the high-coupling efficiency of the LD, and to employ a bare preamplifier mounting to reduce the parasitic capacitance into a preamplifier. We also demonstrate the dynamic performance for a 50-Mb/s burst signal, such as a high sensitivity, an instantaneous AGC response, and a small APC deviation of the transceiver.

収録刊行物

被引用文献 (26)*注記

もっと見る

参考文献 (27)*注記

もっと見る

詳細情報 詳細情報について

  • CRID
    1570572702364025088
  • NII論文ID
    110003220614
  • NII書誌ID
    AA10826283
  • ISSN
    09168524
  • 本文言語コード
    en
  • データソース種別
    • CiNii Articles

問題の指摘

ページトップへ