板すみ肉溶接構造の統一的な疲労強度評価に関する研究 : (第1報) 簡易的なホットスポット応力の算出法について

DOI Web Site 被引用文献4件

書誌事項

タイトル別名
  • Study on Unified Fatigue Strength Estimation Method for Fillet Welded Plate Structures : 1st Report : Simplified Calculating Method of Hot Spot Stress
  • 板すみ肉溶接構造の統一的な疲労強度評価に関する研究-1-簡易的なホットスポット応力の算出法について
  • イタ スミニク ヨウセツ コウゾウ ノ トウイツテキ ナ ヒロウ キョウド ヒ

この論文をさがす

抄録

There is a hot spot stress (H.S.S.) method where a unified S-N curve is used instead of many curves corresponding to joint category for the estimation of fatigue strength of welded structures. In this paper, the hot spot stress method, which is more reasonable and simpler than before, is being discussed for the welded plate structures, ship hull structures, the bogie frame of the rolling stock, etc. First, stress analysis of simple fillet welded models were carried out, by means of boundary element method (BEM) to investigate a simpler calculating method of hot spot stress. As a result, it was found that stress concentration due to weld bead is nearly reduced to zero at the point about 30% thickness of main plate off the weld toe, so long as the plate thickness (t) is within the range used for welded plate structures (3mm<__=t<__=18mm). The authors propose, herein, a simplified H.S.S. calculating method by defining H.S.S. as a stress at 0.3t from the weld toe (0.3t method) for, mainly, ship hull structures. In order to verify the validity of this calculating method of hot spot stress (0.3t method), the fatigue tests have been carried out for two types of the fillet welded joints, i.e., cruciform-tension-type and T-bending-type fillet welded joints. Each type has global stress concentration or no global stress concentration due to the structural discontinuity. But each type has the same local stress concentration due to the weld bead shape. As a result, all S-N data based on hot spot stress range by the 0.3t method gathered within a narrow band independent of structural stress concentration factors. And it has been confirmed that the 0.3t method is applicable for unified fatigue strength estimation of fillet welded plate structures.

収録刊行物

  • 関西造船協会誌

    関西造船協会誌 220 (0), 159-166, 1993

    公益社団法人 日本船舶海洋工学会

被引用文献 (4)*注記

もっと見る

キーワード

詳細情報 詳細情報について

問題の指摘

ページトップへ