射出成形製パンタグラフ機構における大変形ヒンジの繰返し引張・圧縮-曲げ疲労試験(OS7 マイクロメカトロニクス)

DOI Web Site

書誌事項

タイトル別名
  • Bending and Tensile-Compressive Fatigue Test of Hinges in Pantograph Mechanisms made from Injection Molding Machine

抄録

A new surface mount system with a parallel arrangement of miniature manipulators was proposed for use in system down sizing. The miniature manipulator consists of a molded pantograph mechanism, which is composed of large deflective hinges and links, both made of the same materials. The complex and dynamic loads, that is, a combination stress of bending, tensile, compression and shearing stresses, occurs on each hinge in the pantograph mechanism. In these stresses, a hypothesis that bending and tensile stresses are the major factors in the fatigue damage of hinges is set up. On the hypothesis, tensile-compressive and bending conditions with hinge specimen as a fatigue test are carried out. The hinge specimen is made by the injection molding machine, and its material is polypropylene (PP) or the combination of PP and ethylene-propylene-rubber (EPT). By the fatigue test, the durability of hinge made of each material and the damage advance inside of the hinge are investigated experimentally.

収録刊行物

キーワード

詳細情報 詳細情報について

問題の指摘

ページトップへ