Nd:YAG高調波レーザによる窒化アルミニウムの加工特性評価

DOI Web Site 被引用文献1件 参考文献15件

書誌事項

タイトル別名
  • Evaluation of Machining Characteristics of Aluminum Nitride by Harmonics of Nd:YAG Laser
  • Nd YAG コウチョウハ レーザ ニ ヨル チッカ アルミニウム ノ カコウ トクセイ ヒョウカ レーザコウ ノ ハチョウ ガ カコウ トクセイ ニ オヨボス エイキョウ
  • - Effects of Laser Beam Wavelength on Machining Characteristics -
  • －レーザ光の波長が加工特性に及ぼす影響－

この論文をさがす

抄録

Machining characteristics of aluminum nitride by various kinds of the harmonics of Nd:YAG laser, that is the fundamental harmonic (λ1 = 1064nm), the second harmonic (λ2 = 532nm), the third harmonic (λ3 = 355nm) and the forth harmonic (λ4 = 266nm), were experimentally investigated. Since the material removal is mainly performed by thermal processing in the case of long wavelength such as fundamental wavelength, the removal rate greatly decreases with increasing the distance from the focusing point to the tip of removal. Thus, the limit of removal depth was shallow, since the material removal was sensitive to the energy density of laser beam. On the other hand, when the photon energy of laser beam is larger than the bonding energy of material, the material is mainly removed by the photochemical reaction. Thus, the decrease of removal rate was small for shorter wavelength. Therefore, the removal rate increases with decreasing the wavelength of laser beam for long term irradiation under the same energy condition. In the case of deep hole drilling, the drilled depth increases proportionally with the number of laser shot at the beginning region. Therefore, the removal depth could be controlled by the number of laser shot in this region.

収録刊行物

被引用文献 (1)*注記

もっと見る

参考文献 (15)*注記

もっと見る

キーワード

詳細情報 詳細情報について

問題の指摘

ページトップへ