鋼製円錐-円筒ソケット接合の研究  [in Japanese] STUDY ON STEEL CONE-TO-CYLINDER SOCKET CONNECTIONS  [in Japanese]

Access this Article

Search this Article

Author(s)

Abstract

A new type of steel connection was proposed, which is named the cone-to-cylinder socket conneciton. A conical shell is plugged into the open end of a cylinder, and the open mouth of the cone is covered by a lid plate. This new connection is expected to be applied to heads of steel pipe piles, bases of pipe struts, supports of pipe trusses, and pipe-to-pipe connections. Experiment on load carrying capacity demonstrated that the socket connections provide satisfactory strength and rigidity under compression. However, it is recommended that the cone should be welded to the lid plate to prevent out-of-plane deformation of the cone edge. Strengthening of the cylinder edge by installing a ring or by welding to the cone wall was found very effective.

Journal

  • Journal of Structural and Construction Engineering (Transactions of AIJ)

    Journal of Structural and Construction Engineering (Transactions of AIJ) 70(598), 155-162, 2005

    Architectural Institute of Japan

References:  8

Cited by:  2

Codes

  • NII Article ID (NAID)
    110004839865
  • NII NACSIS-CAT ID (NCID)
    AN10438559
  • Text Lang
    JPN
  • Article Type
    Journal Article
  • ISSN
    1340-4202
  • NDL Article ID
    7756447
  • NDL Source Classification
    ZN1(科学技術--建設工学・建設業)
  • NDL Call No.
    Z16-1419
  • Data Source
    CJP  CJPref  NDL  NII-ELS  J-STAGE  AIJ 
Page Top