Residual Stress and Deformation Characteristics of Thermal Barrier Coatings on Curved Substrate
-
- SUZUKI Kenji
- Dept. of Tech. and Living Sci., Niigata Univ.
-
- KAWAMURA Masashi
- Tech. Inst., Kawasaki Heavy Industries, Ltd.
-
- SHOBU Takahisa
- SPring-8 Service Co. Ltd.
-
- TANAKA Keisuke
- Dept. of Mech. Sci. Eng., Nagoya Univ.
-
- AKINIWA Yoshiaki
- Dept. of Mech. Sci. Eng., Nagoya Univ.
Bibliographic Information
- Other Title
-
- 曲面上の遮熱コーティングの残留応力と変形特性
- キョクメン ジョウ ノ シャネツ コーティング ノ ザンリュウ オウリョク ト ヘンケイ トクセイ
Search this article
Abstract
Thermal barrier coatings (TBCs) were made on the round bar substrates of which radii were 5, 10 and 15mm. In addition to the round bar substrates, the TBC was made on a plate substrate. First, NiCoCrAlY was pressureless plasma-sprayed as bond coating, and then zirconia with 8 mol% yittria was air plasma-sprayed as top coating. The TBC specimens were exposed in air atmosphere at 1373K for 0h, 200h or 500h. The radial strain was first measured with the strain scanning method using high energy synchrotron X-rays. The hoop and axial stresses of the round bar specimens were measured using laboratory X-rays with successive removal of the surface by polishing. Using these measured stresses and strain, the distributions of the 3-dimentional components of the residual stress in the top coating were determined. The spalling stress became a maximum at about 50μm apart from the interface. This position corresponded to the location of initiation of the spalling cracks. The maximum of the measured spalling stress increased with the decrese in the radius of curvature. The difference of the measured distribution of the residual stress from the calculated distribution of the thermal residual stress was explained on the basis of the characteristic of the top coatings, such as the stress relaxation due to sliding between lamelli, a binding effect by the interface roughness and the spalling stress induced by the interface roughness.
Journal
-
- Journal of the Society of Materials Science, Japan
-
Journal of the Society of Materials Science, Japan 55 (7), 634-640, 2006
The Society of Materials Science, Japan
- Tweet
Keywords
Details 詳細情報について
-
- CRID
- 1390001205418528768
-
- NII Article ID
- 110006570974
-
- NII Book ID
- AN00096175
-
- ISSN
- 18807488
- 05145163
-
- HANDLE
- 10191/18171
-
- NDL BIB ID
- 8037840
-
- Text Lang
- ja
-
- Data Source
-
- JaLC
- IRDB
- NDL
- Crossref
- CiNii Articles
- KAKEN
-
- Abstract License Flag
- Disallowed