書誌事項
- タイトル別名
-
- 3615 Finite Element Analysis for Identification of Back Surface Crack by Direct Current Potential Difference Method with Auxiliary Current
抄録
In conventional direct-current potential difference method (DC-PDM), uniform current is supplied far from a crack and the change in the potential difference by the crack is measured. The identification of the crack is done based on it. But in the case of a crack on the back surface, the change is not large enough and the identification is usually difficult. In this study, auxiliary current is supplied in addition to the remote uniform current and the improvement of identification of the crack existing on the back surface is investigated using the finite element method. Based on the analysis results, effect of the location of the auxiliary current and its strength on the measured potential difference is discussed.
収録刊行物
-
- 年次大会講演論文集
-
年次大会講演論文集 2006.1 (0), 767-768, 2006
一般社団法人 日本機械学会
- Tweet
詳細情報 詳細情報について
-
- CRID
- 1390001206061186688
-
- NII論文ID
- 110006634635
-
- ISSN
- 24331325
-
- 本文言語コード
- ja
-
- データソース種別
-
- JaLC
- Crossref
- CiNii Articles
-
- 抄録ライセンスフラグ
- 使用不可