C-10 FRICTION AND ADHESION IN DRY WARM FORGING OF MAGNESIUM ALLOY WITH COATED TOOLS(Session: Forming II) C-10 FRICTION AND ADHESION IN DRY WARM FORGING OF MAGNESIUM ALLOY WITH COATED TOOLS(Session: Forming II)

Access this Article

Author(s)

    • Matsumoto Ryo
    • Division of Mechanical Engineering, Graduate School of Engineering Science, Osaka University
    • Kawashima Hiroaki
    • Division of Mechanical Engineering, Graduate School of Engineering Science, Osaka University
    • Osakada Kozo
    • Division of Mechanical Engineering, Graduate School of Engineering Science, Osaka University

Abstract

Frictional behaviour of magnesium alloy AZ31B (Mg-3%Al-1%Zn) is measured with the tapered plug penetration test under dry condition. The cemented tungsten carbide (WC) plugs are coated with diamond like carbon (DLC), TiA1N. The cylindrical hollow billets of AZ31B heated to the temperature of 200℃ are penetrated by the tapered plugs. DLC coating is effective in prevent AZ31B from adhering to the tool surface. To examine the deformation behaviour of the billet during the plug penetration test, the finite element simulation is carried out. From the simulation and experimental results, the coefficient of friction of AZ31B is estimated.

Journal

  • The Proceedings of the Asian Symposium on Materials and Processing

    The Proceedings of the Asian Symposium on Materials and Processing 2006(0), 57, 2006

    The Japan Society of Mechanical Engineers

Codes

Page Top