-
- 高木 純一郎
- 横浜国立大学
書誌事項
- タイトル別名
-
- 3416 Truing of Small Diameter CBN Grinding Wheels by PCD Disk
抄録
In grinding operation, there are two important preparations, truing which forms wheel geometry and conditioning which generates chip pockets around abrasive grains on wheel surface. Truing has very strong influence on the performance of grinding wheel in terms of determining sharpness of grain cutting edges. In this study, truing of CBN wheel by PCD which has excellent wear resistance is attempted and correlations between truing force, grinding force and surface roughness are examined. Very sharp ridge end of PCD disk effectively reduces truing force and eliminate flexure of the quill of small diameter CBN wheels. Also, accuracy of sharpness control of grain cutting edges is improved compared to conventional truing tools.
収録刊行物
-
- 年次大会講演論文集
-
年次大会講演論文集 2008.4 (0), 275-276, 2008
一般社団法人 日本機械学会
- Tweet
キーワード
詳細情報 詳細情報について
-
- CRID
- 1390282681041198336
-
- NII論文ID
- 110007659006
-
- ISSN
- 24331325
-
- 本文言語コード
- ja
-
- データソース種別
-
- JaLC
- Crossref
- CiNii Articles
-
- 抄録ライセンスフラグ
- 使用不可