GDS-04 Measurement of Contact Stress on Tooth Flank of Spur Gear Subject to Static Load : Comparison of analysis with Tooth Flank Film Element(DESIGN AND SYNTHESIS OF A PAIR OF GEARS OR OF GEAR TRAINS)

• MORIWAKI Ichiro

  Kyoto Institute of Technology

• HASHIMOTO Tatsuya

  Graduate School of KIT

• HIRATA Natsuki

  Graduate School of KIT

• NAKAMURA Morimasa

  Kyoto Institute of Technology

• UEDA Akio

  Amtec inc.

抄録

Contact stress between meshing gear tooth flanks is one of the most important factors for the load capacity evaluation of a gear pair. A gear design system was developed using Tooth Flank Film Elements (TFFEs). The TFFEs enable boundary conditions for a contact problem in meshing teeth to be easily dealt with. In order to confirm the reliability of the gear design system, contact stresses between meshing gear flanks of spur gear pair subject to a static load were measured using pressure measurement film, and were compared with calculated ones. In the present paper, contact stresses of a gear pair with some parallel and crossed misalignments were measured, and were com-pared with calculated ones. As a result, even for a gear pair with some parallel misalignments, the Tooth Flank Film Elements can work well, and can yield reasonable contact stresses.

収録刊行物

• The Proceedings of the JSME international conference on motion and power transmissions

  The Proceedings of the JSME international conference on motion and power transmissions 2009 (0), 15-20, 2009

  一般社団法人 日本機械学会

キーワード

• Gear
• Contact Stress
• Misalignment
• Hertzian Contact Stress
• Profile modification
• Tooth Flank Film Element

詳細情報

• CRID: 1390282680868723072
• NII論文ID: 110008009669
• DOI: 10.1299/jsmeimpt.2009.15
• ISSN: 24243043
• Web Site: https://www.jstage.jst.go.jp/article/jsmeimpt/2009/0/2009_15/_pdf
• 本文言語コード: en
• データソース種別:
  • JaLC
  • Crossref
  • CiNii Articles
• 抄録ライセンスフラグ: 使用不可