-
- 澤田 浩之
- 産総研
書誌事項
- タイトル別名
-
- D104 Upstream Design and 1D-CAE
抄録
Engineering design usually starts with a customer need, and then proceeds through several stages: conceptual design, functional design, layout design, structural design and production design. As design proceeds, design information about the artifact becomes concrete and quantified gradually. In the last several decades, computer simulation technologies including FEM have been developed for the later design stages at which correct and concrete numerical information is available. On the other hand, computer support for the earlier design stages is not sufficient due to difficulties in handling ambiguous and qualitative design information. However, it is well known that design at the early stages has a great influence on the final design solution, and designers need design support tools for upstream design. Therefore, we have established a research society for 1D-CAE, which is a general term for idea, methodology and tools applicable for upstream design support, and discuss the concept and definition of 1D-CAE. This paper reports our discussion about 1D-CAE.
収録刊行物
-
- 「運動と振動の制御」シンポジウム講演論文集
-
「運動と振動の制御」シンポジウム講演論文集 2011.12 (0), 221-224, 2011
一般社団法人 日本機械学会
- Tweet
詳細情報 詳細情報について
-
- CRID
- 1390001205886113536
-
- NII論文ID
- 110009619573
-
- ISSN
- 24243000
-
- 本文言語コード
- ja
-
- データソース種別
-
- JaLC
- Crossref
- CiNii Articles
-
- 抄録ライセンスフラグ
- 使用不可