W042003 光ファイバセンサによるFRPの成形モニタリング(【W04200】知的材料・構造システムの現状と今後の展開,機械材料・材料加工部門企画,ワークショップ)

• 高坂 達郎

  高知工科大学

書誌事項

タイトル別名

• W042003 Process Monitoring of FRP by Fiber Optic Sensors

抄録

It has been proven that fiber-optic refractive-index sensors can be used for monitoring cure process of thermosetting resin. In the present paper, process monitoring of GFRP was conducted by embedded refractive-index sensors. The sensors were embedded in 0° and 90° directions of unidirectional GFRP laminates and in resin of prepregs in order to investigate effect of reinforcing fibers on refractive index of resin. The laminates were manufactured at 140℃ and pressure of 0.5 MPa by a hot-press molding device. The experimental results showed that the effect of reinforcing fibers had remained small until cure process finished, however thermal residual stress caused by reinforcements affected refractive index of prepreg at cooling. Therefore, it was found that cure index of FRP prepregs could be measured by refractive-index sensors. In addition, it appeared that the refractive-index sensors were available to monitor air voids in resin qualitatively during molding.

収録刊行物

• 年次大会

  年次大会 2013 (0), _W042003-1-_W042003-5, 2013

  一般社団法人 日本機械学会

キーワード

• Process monitroing
• Cure monitoring
• Smart composites
• FRP
• fiber optic sensors

詳細情報

• CRID: 1390001205841434752
• NII論文ID: 110009931802
• DOI: 10.1299/jsmemecj.2013._w042003-1
• ISSN: 24242667
• Web Site: https://www.jstage.jst.go.jp/article/jsmemecj/2013/0/2013__W042003-1/_pdf
• 本文言語コード: ja
• データソース種別:
  • JaLC
  • Crossref
  • CiNii Articles
• 抄録ライセンスフラグ: 使用不可