書誌事項
- タイトル別名
-
- 121 Aerodynamic specification and flow visualization on disk wheel which produces forward lift
抄録
In recent years, bicycles are attracted as lower environmental burden transfer. Then, amateur competitors keep increasing, and they began to indicate data of aerodynamic specification of bicycle components as frames, spokes, helmets and wheels. This study verified the effects of Sub9 produced by Zipp. Zipp argues this wheel "produce forward lift" in a wind angle of 12 to 18 degrees. Therefore, we made 3 kinds of wheels, plain disk, normal disk wheel and Sub9 model. Those were used as a drag force measurement and flow visualization, and investigated in non-rotate conditions and rotate conditions. Drag force of each model was measured with three components load cell. Flow visualization in a smoke wind tunnel was also carried out in a vertical plane. As a result, Sub9 produced little thrust over wind angle of 16 degrees. Plain disk have similar specification to Sub9, and normal disk wheel is the worst wheel in this study. The results of the flow visualization also explain these phenomena well.
収録刊行物
-
- シンポジウム: スポーツ・アンド・ヒューマン・ダイナミクス講演論文集
-
シンポジウム: スポーツ・アンド・ヒューマン・ダイナミクス講演論文集 2013 (0), _121-1_-_121-4_, 2013
一般社団法人 日本機械学会
- Tweet
詳細情報 詳細情報について
-
- CRID
- 1390282680878565632
-
- NII論文ID
- 110009935702
-
- ISSN
- 24329509
-
- 本文言語コード
- ja
-
- データソース種別
-
- JaLC
- Crossref
- CiNii Articles
-
- 抄録ライセンスフラグ
- 使用不可