507 発泡アルミニウムの表面緻密層成形における摩擦撹拌インクリメンタルフォーミングと圧縮加工の比較  [in Japanese] 507 Comparison of Friction Stir Incremental Forming and Uniaxial Compression in Fabrication of Solid Skin on Aluminum Foam Surface  [in Japanese]

Access this Article

Search this Article

Author(s)

Abstract

The friction stir incremental forming method was possible to fabricate the solid skin layer with thinner than 0.4mm on the surface of closed-cell type aluminum foam (Shinko Wire Company, Ltd.: ALPORAS, relative density 0.1, mean diameter of pore φ4 mm) without causing fracture the inside The area fraction of metal matrix at the surface was obtained as about 80% in forming conditions of tool rotation rate of higher than 8000 rpm and tool feed rate of 60mm min^<-1> The solid skin layers fabricated the friction stir incremental forming, incremental hammering and uniaxial compression methods were compared

Journal

  • The Proceedings of the Materials and processing conference

    The Proceedings of the Materials and processing conference 2013.21(0), _507-1_-_507-3_, 2013

    The Japan Society of Mechanical Engineers

Codes

  • NII Article ID (NAID)
    110009935937
  • Text Lang
    JPN
  • NDL Article ID
    025693140
  • NDL Call No.
    YH247-1044
  • Data Source
    NDL  NII-ELS  J-STAGE 
Page Top