G0310201 多結晶純チタン表面に設けた平行溝間およびV字断面溝内微小領域の圧縮塑性変形(材料力学部門一般セッション:変形・ひずみ(2))

DOI Web Site

書誌事項

タイトル別名
  • G0310201 Compressive Plastic Deformation in Micro Areas between Parallel Grooves and in V-shaped Cross-Section Groove Fabricated on Polycrystalline Pure Titanium Surface

抄録

The compressive deformation behavior in micro areas of industrial pure titanium was investigated, by using a new method in which the deformation constraints from the neighboring areas were reduced by fabricating micro parallel grooves or V-shaped cross-section grooves, by focused ion beam machining. Uniaxial compression test was performed in the direction parallel to the grooves, and the deformation behavior in the areas between the grooves was observed by scanning electron microscopy. The parallel grooves were fabricated to across the deformation twin that appeared by pre-compression, and then the influence of deformation constraint on twinning was discussed. Meanwhile, the V-shaped cross-section grooves were fabricated on several grains to examine the crystal orientation dependency of the deformation of the micro areas. In both cases, the possibility was found to change the primary deformation mechanism in the areas by fabricating micro grooves.

収録刊行物

  • 年次大会

    年次大会 2014 (0), _G0310201--_G0310201-, 2014

    一般社団法人 日本機械学会

キーワード

詳細情報 詳細情報について

問題の指摘

ページトップへ