P-43 SiCによるPEEK(polyether ether ketone)の研磨特性と表面性状 : 歯科切削加工用レジンとの比較(器械・技術,一般講演(ポスター発表),第66回日本歯科理工学会学術講演会)
書誌事項
- タイトル別名
-
- P-43 Surface characteristics of PEEK by SiC polishing : Comparison of polishing characteristics of restorative resins for CAD/CAM
この論文をさがす
抄録
The aim of this study was to characterize the surface properties of PEEK and CAD/CAM resins, CAM-A and CAM-B, by SiC polishing. Two way polishing unit was used with a waterproof P#1200-SiC paper. Mean wear rate was calculated based on the polishing pressure and sliding distance. The surface properties were analyzed with AFM. The mean wear rate of PEEK, CAM-A and CAM-B was about 0.5, 1.9 and 0.5 mm^3/Nm, respectively. The surface roughness (Ra) of these specimens was around 0.51, 0.29 and 0.23 μm, respectively. These results indicated that PEEK can be used as a material for CAD/CAM resin.
収録刊行物
-
- 日本歯科理工学会誌
-
日本歯科理工学会誌 34 (5), 387-, 2015-09-15
一般社団法人日本歯科理工学会
- Tweet
詳細情報 詳細情報について
-
- CRID
- 1572261552778656768
-
- NII論文ID
- 110009985351
-
- NII書誌ID
- AA12452694
-
- ISSN
- 18844421
-
- 本文言語コード
- ja
-
- データソース種別
-
- CiNii Articles