S044024 コールドスプレー法で作製した銅皮膜内部の粒子間界面性状評価

DOI Web Site
  • 渡邊 雄亮
    東北大学大学院工学研究科ナノメカニクス専攻
  • 市川 裕士
    東北大学大学院工学研究科附属エネルギー安全科学国際研究センター
  • 野中 勇
    東北大学大学院工学研究科附属エネルギー安全科学国際研究センター
  • 三浦 英生
    東北大学大学院工学研究科附属エネルギー安全科学国際研究センター

書誌事項

タイトル別名
  • S044024 Evaluation of the microstructure around the particle interface in the cold-sprayed copper deposit

抄録

A cold-spray (CS) method is a new technology which collides fine particles with a solid surface and make a deposit on it. The CS method can produce a thick deposit with little heat affect. Although the strength of this thick deposit is high comparing with bulk material, it often shows brittle fracture. The brittle fracture was found to occur at the interface between the deposited particles. The authors, therefore, observed the difference in the micro texture around the grain boundaries in each particle and that around the interface between the deposited particles in the cold-sprayed copper deposit by an EBSD (Electron backscatter diffraction) method. It was found that the average grain size in the deposited particles was much smaller than that in the particles before deposition. This fine grain size is the reason for the high strength of the deposit. However, there is no difference in the misorientation angle distribution between them. Thus, the microstructure around the interface between the deposited particles should be analyzed more in detail.

収録刊行物

  • 年次大会

    年次大会 2012 (0), _S044024-1-_S044024-4, 2012

    一般社団法人 日本機械学会

キーワード

詳細情報 詳細情報について

問題の指摘

ページトップへ