A Method for Standardizing Parts with Integer Programming

Access this Article

Search this Article

Abstract

A method for standardizing parts is proposed. This method aims to reduce the sort of parts for cutting the manufacturing cost and for improving specifications of parts. Two linear mathematical programming models are proposed for standardizing the parts. One model aims at cutting cost half without causing any degradation ofmechanical specifications of parts. The other model aims at doubling mechanical specifications of parts below the acceptable manufacturing cost. These models are formulated in 0-1 integer programming forms. The integer programming model shows which part is common to other parts. An example is shown to demonstrate the use of the developed method.

Journal

  • Memoirs of the Faculty of Engineering, Okayama University

    Memoirs of the Faculty of Engineering, Okayama University 30(1), 1-7, 1995-12-28

    Faculty of Engineering, Okayama University

Codes

  • NII Article ID (NAID)
    120002307491
  • NII NACSIS-CAT ID (NCID)
    AA10699856
  • Text Lang
    ENG
  • Article Type
    departmental bulletin paper
  • ISSN
    0475-0071
  • Data Source
    IR 
Page Top