Development of novel detection reagent for simple and sensitive determination of trace amounts of formaldehyde and its application to flow injection spectrophotometric analysis
この論文をさがす
抄録
In this paper, a novel detection reagent for formaldehyde determination is proposed, and is applied to a simple and highly sensitive flow injection method for the spectrophotometric determination of formaldehyde. The method is based on the reaction of formaldehyde with methyl acetoacetate in the presence of ammonia. The increase in the absorbance of the reaction product was measured at 375 nm. An inexpensive light emitting diode (LED)based UV detector (375 nm) was, for the first time, used. Under the optimized experimental conditions, formaldehyde in an aqueous solution was determined over the concentration range from 0.25 to 20.0 x 10(-6) M with a liner calibration graph; the limit of detection (LOD) of 5 x 10(-8) M (1.5 mu g L-1) was possible. The relative standard deviation of 12 replicate measurements of 5 X 10(-6) M formaldehyde was 1.2%. Maximum sampling throughput was about 21 samples/h. The effect of potential interferences such as metals, organic compounds and other aldehyde was also examined. The analytical performance for formaldehyde determination was compared with those obtained by the conventional acetylacetone method, which uses visible absorption spectrophotometry. Finally, the proposed method was successfully applied to the determination of formaldehyde in natural water samples.
収録刊行物
-
- Analytica Chimica Acta
-
Analytica Chimica Acta 612 (2), 165-172, 2008-04
Elsevier Science B.V.
- Tweet
キーワード
詳細情報 詳細情報について
-
- CRID
- 1050846637265284608
-
- NII論文ID
- 120002309401
-
- NII書誌ID
- AA00524834
-
- ISSN
- 00032670
-
- 本文言語コード
- en
-
- 資料種別
- journal article
-
- データソース種別
-
- IRDB
- CiNii Articles