Practical aspects of Kelvin-probe force microscopy at solid/liquid interfaces in various liquid media

HANDLE オープンアクセス

この論文をさがす

抄録

The distributions of surface charges or surface potentials on biological molecules and electrodes are directly related to various biological functions and ionic adsorptions, respectively. Electrostatic force microscopy and Kelvin-probe force microscopy (KFM) are useful scanning probe techniques that can map local surface charges and potentials. Here, we report the measurement and analysis of the electrostatic and capacitive forces on the cantilever tip induced by application of an alternating voltage in order to discuss the feasibility of measuring the surface charge or potential distribution at solid/liquid interfaces in various liquid media. The results presented here suggest that a nanometer-scale surface charge or potential measurement by the conventional voltage modulation techniques is only possible under ambient conditions and in a non-polar medium and is difficult in an aqueous solution. Practically, the electrostatic force versus dc voltage curve in water does not include the minimum, which is used for the surface potential compensation. This is because the cantilever oscillation induced by the electrostatic force acting on the tip apex is overwhelmed by the parasitic oscillation induced by the electrostatic force acting on the entire cantilever as well as the surface stress effect. We both experimentally and theoretically discuss the factors which cause difficulties in application of the voltage modulation techniques in the aqueous solutions and present some criteria for local surface charge and potential measurements by circumventing these problems.

収録刊行物

詳細情報 詳細情報について

  • CRID
    1050001335797006720
  • NII論文ID
    120005496652
  • NII書誌ID
    AA00693547
  • ISSN
    00218979
  • HANDLE
    2433/191123
  • 本文言語コード
    en
  • 資料種別
    journal article
  • データソース種別
    • IRDB
    • CiNii Articles

問題の指摘

ページトップへ