Development of a Methane Steam Reformer Using an Electrically Heated Alumite Catalyst: Start-Up Performance Investigated by the Numerical and Experimental Analysis
-
- Zhang Qi
- Department of Chemical Engineering, Faculty of Engineering, Tokyo University of Agriculture and Technology
-
- Guo Yu
- Department of Chemical Engineering, Faculty of Engineering, Tokyo University of Agriculture and Technology
-
- Zhou Lu
- Department of Chemical Engineering, Faculty of Engineering, Tokyo University of Agriculture and Technology
-
- Sakurai Makoto
- Department of Chemical Engineering, Faculty of Engineering, Tokyo University of Agriculture and Technology
-
- Kameyama Hideo
- Department of Chemical Engineering, Faculty of Engineering, Tokyo University of Agriculture and Technology
この論文をさがす
抄録
A cylindrical methane steam reformer using an electrically heated alumite catalyst (EHAC), i.e., Ni/Al2O3/Alloy catalyst, was introduced in this work. The relevant 2D dynamic model has been developed to reveal the key factors to improve the reformer’s performance in concepts of heat and mass transfer. Various strategies to improve the reformer’s reaction and start-up performance were discussed by numerical investigations. Based on the simulation results, the cylindrical reformer was experimented. The experimental results showed that the reformer has a fast start-up and quick response for the load fluctuation by the internal heating through the EHAC.
収録刊行物
-
- JOURNAL OF CHEMICAL ENGINEERING OF JAPAN
-
JOURNAL OF CHEMICAL ENGINEERING OF JAPAN 40 (6), 487-496, 2007
公益社団法人 化学工学会
- Tweet
詳細情報 詳細情報について
-
- CRID
- 1390282679544034048
-
- NII論文ID
- 130000018987
-
- NII書誌ID
- AA00709658
-
- ISSN
- 18811299
- 00219592
-
- NDL書誌ID
- 8773960
-
- 本文言語コード
- en
-
- データソース種別
-
- JaLC
- NDL
- Crossref
- CiNii Articles
- KAKEN
-
- 抄録ライセンスフラグ
- 使用不可