Single-Point Incremental Micro-Forming of Thin Shell Products Utilizing High Formability
-
- OBIKAWA Toshiyuki
- Institute of Industrial Science, The University of Tokyo
-
- HAKUTANI Tomomi
- Department of Mechanical and Control Engineering, Tokyo Institute of Technology
-
- SEKINE Tsutomu
- Department of Mechanical and Control Engineering, Tokyo Institute of Technology
-
- NUMAJIRI Shogo
- Department of Mechanical Engineering, Tokyo Denki University
-
- MATSUMURA Takashi
- Department of Mechanical Engineering, Tokyo Denki University
-
- YOSHINO Masahiko
- Department of Mechanical and Control Engineering, Tokyo Institute of Technology
抄録
This paper describes single-point incremental micro-forming of miniature shell products 50 µm to 1000 µm in size. First, the conditions of the micro-forming of a pyramid with a 1 mm square base were optimized to cause large elongation of a blank up to 128%, resulting in a tall pyramid with an elevation angle of 64°. Next, the influence of the tool rotational speed on the forming limit in forming a pyramid with a 50 µm square base was investigated. It was found that the optimum rotational speed decrease with the size of a pyramid. Finally, letters and numbers 100 µm to 500 µm in size were formed as free form products. The effect of grain size on the miniature shell products was discussed based on the results and it was concluded that the effect must be taken into consideration in micro-forming processes of miniature products smaller than 100 µm in size as far as the grain size is not very small as compared with the size of a product.
収録刊行物
-
- Journal of Advanced Mechanical Design, Systems, and Manufacturing
-
Journal of Advanced Mechanical Design, Systems, and Manufacturing 4 (6), 1145-1156, 2010
一般社団法人 日本機械学会
- Tweet
詳細情報 詳細情報について
-
- CRID
- 1390282680247563904
-
- NII論文ID
- 130000428121
-
- ISSN
- 18813054
-
- 本文言語コード
- en
-
- データソース種別
-
- JaLC
- Crossref
- CiNii Articles
- KAKEN
-
- 抄録ライセンスフラグ
- 使用不可
