混練型ＷＰＣの混練特性に及ぼす木粉の疎水化の影響

DOI Web Site 参考文献4件

書誌事項

タイトル別名
  • Effects of Hydrophobic Wood Flour on Mixing Properties of Compound-Type Wood Plastic Composites
  • コンレンガタ WPC ノ コンレントクセイ ニ オヨボス モクフン ノ ソスイカ ノ エイキョウ

この論文をさがす

抄録

In a production of compound-type wood plastic composite (WPC), hydrophobic treatments of wood elements were expected to improve interfacial adhesion between hydrophilic woods and hydrophobic plastics. However, some of results obtained by such process did not show improvements on mechanical properties of resultant products. This difference in an effectiveness of hydrophobic treatments of wood seemed to be caused by the mixing and compounding conditions for treated woods and plastics used in previous studies. There were a few studies focused on the mixing condition in WPC productions for treated wood elements. From these points of view, WPC was prepared from hydrophobized wood flour by acetylation (A-WF) and commercialized polypropylene (PP) to investigate the mixing properties as well as the mechanical properties. A blend of wood flour with PP in same weight was compounded in a closed mixing blender under the condition that mixing time was varied from 5 to 30 min at a constant temperature of 180°C with a constant blender revolution of 30rpm. The mixing properties were evaluated by measuring the torque change during the mixing and the dispersion state of the untreated/treated wood flour in the PP compounded in each mixing time. As evaluation of the mechanical properties, the static bending modulus and the impact strength were measured. Results were summarized as follows; 1) It was found from microscopic observations that A-WF has poor dispersiveness than that of the untreated wood flour. 2) By increasing mixing time, the flexural modulus of the WPC tended to be slightly decreased, although the impact strength was obviously improved. 3) By the SEM examination, the A-WF improved interfacial wetting between the wood flour and the PP and increased mutual contact surface by deformation due to softening in the mixing temperature. From the results, it appeared that dispersiveness was changed by hydrophobization of wood and the mechanical properties were consequently affected by this change.

収録刊行物

  • 材料

    材料 60 (4), 306-311, 2011

    公益社団法人 日本材料学会

参考文献 (4)*注記

もっと見る

キーワード

詳細情報 詳細情報について

問題の指摘

ページトップへ