SLIP-LINE ANALYSIS FOR POWDER COMPRESSION

Access this Article

Author(s)

    • AOKI RYUICHI
    • Dept. of Chem. Eng., The Faculty of Engineering, Yokohama National University
    • SUZUKI MASAYUKI
    • Dept. of Chem. Eng., The Faculty of Engineering, Yokohama National University

Abstract

From an analogy of the slip-line analysis of metal plastic working, the slip-lines in the stress field of a powder bed compressed by rough parallel plates were drawn and the normal stresses on the wall were calculated using Coulomb''s equation. These calculated values were compared with the experimental data, and the following conclusions were drawn;<br> (1) Under the critical stress state, the compressed powders reveal the same behavior of a continuum as far as it is possible to analyze neglecting the bed density.<br> (2) The powder yield locus for the compress!ve stress field cannot be a Coulomb type straight line, but is a Farley-Valentin type curve convexing to the left.

Journal

  • JOURNAL OF CHEMICAL ENGINEERING OF JAPAN

    JOURNAL OF CHEMICAL ENGINEERING OF JAPAN 2(2), 235-238, 1969

    The Society of Chemical Engineers, Japan

Codes

  • NII Article ID (NAID)
    130000788125
  • Text Lang
    ENG
  • ISSN
    0021-9592
  • Data Source
    J-STAGE 
Page Top