ガラス基板への通り穴加工におけるステップ加工時の加工条件と欠けの抑制

• 溝渕 啓

  徳島大学大学院

• 小川 仁

  徳島県立工業技術センター

• 升田 雅博

書誌事項

タイトル別名

• Drilling Conditions and Crack Restraint of Step Drilling Method in Through-Hole Drilling of Glass Plate
• ガラス キバン エ ノ トオリ アナカコウ ニ オケル ステップ カコウジ ノ カコウ ジョウケン ト カケ ノ ヨクセイ

抄録

Hard and brittle materials such as ceramics and glass are not only difficult-to-machine but also occur easily cracks at the exit surface in through-hole drilling. This paper deals with through-hole drilling of soda-lime glass plate using an electroplated diamond tool in order to find out drilling conditions for smaller cracks, higher processing efficiency and longer tool life. The crack is smallest under a spindle revolution of 15000min^-1, a feed speed of 1mm/min, a step feed of 0.1mm/step and a mesh size of #600. A large decrease of thrust force results from the penetration that the large cracks occur. The maximum diameter included the crack is smaller than that of the tool. The residual is removed as the tool feeds. The cracks at the exit increase with the drilling numbers. The drilling time is about 430s per a hole.

収録刊行物

• 精密工学会誌

  精密工学会誌 77 (3), 296-300, 2011

  公益社団法人 精密工学会

キーワード

• glass plate
• electroplated diamond tool
• through-hole
• thrust force
• cracks
• drilling conditions

詳細情報

• CRID: 1390282679775025792
• NII論文ID: 130001002518
• NII書誌ID: AN1003250X
• DOI: 10.2493/jjspe.77.296
• ISSN: 1882675X
• ISSN: 09120289
• NDL書誌ID: 11033074
• Web Site: https://ndlsearch.ndl.go.jp/books/R000000004-I11033074
• 本文言語コード: ja
• データソース種別:
  • JaLC
  • NDL
  • Crossref
  • CiNii Articles
• 抄録ライセンスフラグ: 使用不可