書誌事項
- タイトル別名
-
- A Solution for Optimal Order Splitting Policy of Make-to-Order Manufacturing Systems Based on Penalty for Delay in Appointed Date of Delivery
- ノウキ オクレ ニ タイスル ペナルティ オ コウリョ シタ ジュチュウ セイサン システム ノ サイテキ ハッチュウ ホウサク ニ カンスル イチカイホウ
この論文をさがす
抄録
Manufacturing systems are classified into make-to-stock (MTS) systems and make-to-order (MTO) systems. In particular, the MTO manufacturing systems have been applied to many enterprises in order to react to consumer's uncertain demands and various requirements. Until now, in the studies for the order splitting policy to some original equipment manufacturers (OEMs) under the MTO manufacturing systems, the expectation of the lead time has been mainly considered. In general, the lead-time has the variability because of the fluctuations of the processing time and the demand. Therefore, when the optimal operation of the MTO manufacturing systems is investigated, we should consider the possibility of the delay for the appointed date of delivery of products. In this study, taking the penalty of the delay of delivery into consideration, we investigate the order splitting policy to two OEMs having the difference in the processing cost and the capacity.
収録刊行物
-
- システム制御情報学会論文誌
-
システム制御情報学会論文誌 18 (3), 100-107, 2005
一般社団法人 システム制御情報学会
- Tweet
キーワード
詳細情報 詳細情報について
-
- CRID
- 1390001205166013824
-
- NII論文ID
- 130002037796
-
- NII書誌ID
- AN1013280X
-
- ISSN
- 2185811X
- 13425668
-
- NDL書誌ID
- 7274564
-
- 本文言語コード
- ja
-
- データソース種別
-
- JaLC
- NDL
- Crossref
- CiNii Articles
-
- 抄録ライセンスフラグ
- 使用不可