Influence of Motion Errors of Feed Drive Systems on Machined Surface

• NISHIO Kentaro

  Department of Mechanical Engineering, Graduate School of Engineering, Kobe University

• SATO Ryuta

  Department of Mechanical Engineering, Graduate School of Engineering, Kobe University

• SHIRASE Keiichi

  Department of Mechanical Engineering, Graduate School of Engineering, Kobe University

抄録

The purpose of this study is to clarify the relationship between the dynamic motion errors of feed drive systems and the machined surfaces. To achieve this purpose, a simulation method for a machined surface by peripheral milling is proposed. In the proposed method, the motion errors of a feed drive system and the machined surface are simulated based on tool diameter, number of flutes, spindle speed, and feed speed. In addition, to clarify the correctness of the proposed method, actual cutting tests are carried out. In the cutting tests, the control parameters of the machine tool are intentionally changed to obtain the motion errors. As the results of the cutting tests, it is confirmed that the influence of the motion errors of feed drive systems on machined surface can be predicted by the proposed simulation method. The relationship between the motion errors and machined surfaces is also examined based on the simulations.

収録刊行物

• Journal of Advanced Mechanical Design, Systems, and Manufacturing

  Journal of Advanced Mechanical Design, Systems, and Manufacturing 6 (6), 781-791, 2012

  一般社団法人 日本機械学会

キーワード

• NC Machine Tools
• Feed Drive Systems
• Machined Surface
• Motion Error
• Simulation

詳細情報

• CRID: 1390001205273083520
• NII論文ID: 130002099510
• DOI: 10.1299/jamdsm.6.781
• BIBCODE: 2012JAMDS...6..781N
• ISSN: 18813054
• Web Site: https://www.jstage.jst.go.jp/article/jamdsm/6/6/6_781/_pdf
• 本文言語コード: en
• データソース種別:
  • JaLC
  • Crossref
  • CiNii Articles
  • KAKEN
• 抄録ライセンスフラグ: 使用不可