Wear of Gas Nitrosulfurized Alloy Steels

• Momose Osamu

  School of Engineering, Tokai University

• Uchida Sosuke

  School of Engineering, Tokai University

抄録

The nitrosulfurized layer and wear property of gas nitrosulfurized alloy steels were studied. Test pieces of SNC 631, SCr 430 and S45C steels were treated in an atmosphere of the 50%NH₃, 0.02%H₂S and propane converted carrier gas at 843 K for 10.8 ks. It was comfirmed by X-ray diffraction that the main surface products were Fe_1−xS, FeS, Fe₃N and Fe₄N in each specimen. A compound layer was observed in the microstructure of the cross section of treated specimens. The hardness of the compound layer was higher in the order of S45C, SNC 631 and SCr 430. The wear test was carried out under the condition of 490 kPa using a pin-ring system wear tester without luburication. It was found that the gas nitrosulfurizing of steels improved wear resistance of steels because the compound layer formed on the treated specimens reduced the adhesion of the sliding plane, and this effect was remarkable on the alloy steels.

収録刊行物

• Transactions of the Japan Institute of Metals

  Transactions of the Japan Institute of Metals 23 (3), 146-151, 1982

  社団法人 日本金属学会

キーワード

• General Engineering

詳細情報

• CRID: 1390001205117944192
• NII論文ID: 130003485975
• DOI: 10.2320/matertrans1960.23.146
• ISSN: 24324701
• ISSN: 00214434
• Web Site: https://www.jstage.jst.go.jp/article/matertrans1960/23/3/23_3_146/_pdf
• 本文言語コード: en
• データソース種別:
  • JaLC
  • Crossref
  • CiNii Articles
• 抄録ライセンスフラグ: 使用不可