50 高能率熔接棒製造機の試作研究

• 岡田 実

  大阪大学工学部

• 飛田 一治

  株式会社大阪東光社

• 和田 耕右

  株式会社大阪東光社

書誌事項

タイトル別名

• Researches on a Trial Manufacture of High Efficiency Coating Machine of Welding-rods

抄録

Okada's screw-conveyer type coating machine has strong points in continuous operation, less material and floor space are needed, and having comparatively high working efficiency. The experimentally manufactured machine No.1 showed some defects in design, and some difficulties on fabrication. The authors have successfully manufactured machine No.2 after four years of devotion to improve the weak points found in the machine No. 1.<BR>This paper is divided into the following four sections aiming to explain principles applied to remodel the original one comparing the machine No.1 and No. 2.<BR>A) Equipment to feed core wire.<BR>B) Equipment to supply flux by pressure.<BR>C) Equipment to hold and drop coated rod.<BR>D) Equipment to convey and dry coated rod.<BR>Results of the investigation are discussed. Weak points are pointed out and suggestions for further improvement are given in the conclusion.

収録刊行物

• 溶接学会誌

  溶接学会誌 19 (3), 57-62, 1950

  一般社団法人 溶接学会

キーワード

• Metals and Alloys
• Surfaces, Coatings and Films
• Mechanical Engineering
• Mechanics of Materials

詳細情報

• CRID: 1390282681478360832
• NII論文ID: 130003762488
• DOI: 10.2207/qjjws1943.19.57
• ISSN: 18837204
• ISSN: 00214787
• 本文言語コード: ja
• データソース種別:
  • JaLC
  • Crossref
  • CiNii Articles
• 抄録ライセンスフラグ: 使用不可