球状黒鉛鋳鉄の固相接合 (第4報) 球状黒鉛鋳鉄固相接合材の衝撃特性

書誌事項

タイトル別名
  • Solid state bonding of spheroidal graphite cast irons. (Report 4). Impact characteristics of solid state bonded joints of ferritic spheroidal craphite cast iron.
  • Solid State Bonding of Spheroidal Graphite Cast Irons (Report 4)
  • 球状黒鉛鋳鉄の固相接合(第4報)

抄録

Impact characteristics of diffusion bonded joints of ferritic shperoidal graphite cast iron and the cast iron to mild steel have been investigated using an instrumented Charpy impact test machine. The tests were performed at 0°C after ferritizing the joints. Main results obtained are as follows; (1) Absorbed energy of the cast iron joints bonded without an insert metal had about 5 J, which was much lower than that of the base metal. (2) Absorbed energy of the cast iron joints bonded with Ni foil as an insert metal became higher than that of the joint without Ni foil. The absorbed energy increased with the increas of the thickness of Ni feil and the absorbed energy was reached the base metal level when 50-μm thick Ni foil was used an insert metal. (3) Bond toughness of the cast iron to the mild steel joint bonded without the insert metal increased with the increase of the bonding temperature. When the bonding temperature was upper than 900°C, the absorbed energy was higher than that specified by Japanese Industrial Standard, which is 12.7 J. (4) Bond toughness of the cast iron to the mild steel joints bonded with Ni foil of 10 or 20μm in thickness at 820°C was almost the same as that of the cast iron base metal.

収録刊行物

被引用文献 (2)*注記

もっと見る

詳細情報 詳細情報について

  • CRID
    1390282679701221504
  • NII論文ID
    130003764874
  • DOI
    10.2207/qjjws.8.97
  • ISSN
    24348252
    02884771
  • 本文言語コード
    ja
  • データソース種別
    • JaLC
    • Crossref
    • CiNii Articles
  • 抄録ライセンスフラグ
    使用不可

問題の指摘

ページトップへ