書誌事項
- タイトル別名
-
- PROCESSABILITY OF T-DIE EXTRUSION
- Tダイキャスト セイケイ ノ セイケイセイ ニ カンスル ケンキュウ
この論文をさがす
抄録
In achieving the high productivity or producing the thin film on the T-die extrusion, processability which includes instability and film failure is often a big problem. Processability was discussed by using the theoretical analysis previously reported.<br>Instability was evaluated by dimensionless deformation rate which was suggested by Toriumi, and film failure was estimated by maximum stretching stress at the roll touch. Cooling air blowed off from an air knife which much influences processability made dimensionless deformation rate smaller, and it made stability better. As a result of the experiment in the various resins and process conditions, it was found that processability was dependent on dimensionless deformation rate and draw down ratio. Film failure was mainly influenced by maximum stretching stress.
収録刊行物
-
- 繊維学会誌
-
繊維学会誌 42 (1), T1-T10, 1986
社団法人 繊維学会
- Tweet
キーワード
詳細情報 詳細情報について
-
- CRID
- 1390001204863853056
-
- NII論文ID
- 130004204114
-
- NII書誌ID
- AN00131651
-
- ISSN
- 18842259
- 00379875
-
- NDL書誌ID
- 3069670
-
- データソース種別
-
- JaLC
- NDL
- Crossref
- CiNii Articles
-
- 抄録ライセンスフラグ
- 使用不可