Effect of Nanocrystallization and Twinning on Hardness in Ni<SUB>3</SUB>Al Deformed by High-Pressure Torsion

Access this Article

Author(s)

    • Ciuca Octav
    • Dept. of Production Systems Engineering, Toyohashi University of Technology|Innovative Materials Engineering Laboratory, National Institute for Materials Science
    • Tsuchiya Koichi
    • Dept. of Production Systems Engineering, Toyohashi University of Technology|Innovative Materials Engineering Laboratory, National Institute for Materials Science
    • Todaka Yoshikazu
    • Dept. of Production Systems Engineering, Toyohashi University of Technology
    • Umemoto Minoru
    • Dept. of Production Systems Engineering, Toyohashi University of Technology

Abstract

Samples of Ni<SUB>3</SUB>Al intermetallic compound were subjected to deformation by high-pressure torsion (HPT). The plastically-deformed structure revealed a bimodal character: coarse grains, retaining a degree of long-range order, surrounded by regions of nanocrystalline, disordered grains. It was inferred that the grain refinement proceeds in an inhomogeneous manner throughout the sample. Grains as large as 100 nm in size were shown to contain only a low density of perfect dislocations, but a large density of nanotwins and stacking faults. These planar defects appeared to originate from the grain boundaries, suggesting that grain boundaries are active sources for Shockley-partial dislocations. Their formation is accompanied by a deviation of the microhardness dependence on grain size from the Hall-Petch behavior, potentially suggesting the activation of a deformation mechanism different from the one acting in coarse structures. The hardness saturates at a significantly larger grain size than in the case of nanostructured pure Ni.

Journal

  • MATERIALS TRANSACTIONS

    MATERIALS TRANSACTIONS 50(5), 1123-1127, 2009

    The Japan Institute of Metals and Materials

Codes

Page Top