Multi-Phase-Field Simulation of Flow Stress and Microstructural Evolution during Deformation-Induced Ferrite Transformation in a Fe–C Alloy
-
- Yamanaka Akinori
- Division of Advanced Mechanical Systems Engineering, Institute of Engineering, Tokyo University of Agriculture and Technology
-
- Takaki Tomohiro
- Graduate School of Science and Technology, Kyoto Institute of Technology
抄録
Deformation-induced ferrite transformation (DIFT) is one of the most effective ways of refining ferrite grains in steel. In this study, we employed a multi-phase-field (MPF) model to simulate both variations in macroscopic flow stress and microstructural evolution during DIFT. Using the MPF model, two-dimensional simulations of DIFT in a Fe–C alloy were performed to investigate the effects of strain rate, austenite grain size, and dynamic recrystallization (DRX) of the ferrite phase on flow stress curve and ferrite grain size. The results demonstrated that increasing the rate of ferrite nucleation by increasing the strain rate and reducing the austenite grain size is essential to obtaining fine-grained ferrite. The results of the simulations also indicated that it is important to reduce the interfacial mobility and increase the nucleation rate of the ferrite grains subjected to DRX in order to obtain ultrafine-grained ferrite by DIFT when it is accompanied by DRX of the ferrite phase. Thus, the MPF model is an effective tool for elucidating the correlation between the variation in the flow stress and the evolution of the ferrite grains during DIFT.
収録刊行物
-
- ＩＳＩＪ Ｉｎｔｅｒｎａｔｉｏｎａｌ
-
ＩＳＩＪ Ｉｎｔｅｒｎａｔｉｏｎａｌ 54 (12), 2917-2925, 2014
一般社団法人 日本鉄鋼協会
- Tweet
キーワード
詳細情報 詳細情報について
-
- CRID
- 1390282681465697408
-
- NII論文ID
- 130004734453
-
- ISSN
- 13475460
- 09151559
-
- 本文言語コード
- en
-
- データソース種別
-
- JaLC
- Crossref
- CiNii Articles
- KAKEN
-
- 抄録ライセンスフラグ
- 使用不可