Hydrogel Formation of Bisphosphonate Around Apatite Coated Titanium Web

DOI
  • HAYAKAWA Tohru
    Department of Dental Biomaterials, Nihon University, School of Dentistry at Matsudo, Chiba, Japan
  • FUKUSHIMA Tadao
    Department of Dental engineering, Bioengineering Section, Fukuoka Dental College, Fukuoka Japan
  • WADA Takeshi
    Wada Dental Clinic, Yamanashi, Japan
  • YOSHINARI Masao
    Division of Oral Implants Research, Oral Health Science Center, Tokyo Dental College, Chiba, Japan
  • SATO Mitsunobu
    Coordination Engineering Laboratory, Faculty of Engineering, Kogakuin University, Tokyo, Japan

この論文をさがす

抄録

The hydrogel formation of bisphosphonate was investigated after the immersion of apatite coated titanium web (TW) in bisphosphonate solution. Apatite thin film was coated onto TW (porosity of 85 %, pore size of 200-300 µm) using molecular precursor method. Molecular precursor solution was obtained by adding dibutylammonium diphosphate salt to Ca-EDTA/amine ethanol solution by adjusting Ca/P=1.67. Sintered cylindrical TW (2.8mm diameter x 6 mm length) was immersed into molecular precursor solution and then heated at 600 °C for 2 hr. The immersion and heating process was repeated three times. Uncoated and apatite coated TW were immersed into the bisphosphonate solution (pamidronate disodium, 1x10-2M) for 24 hr at 37 °C. The viscosity of bisphosphonate solution in apatite coated TW was increased. The formation of hydrogel was clearly observed around the apatite coated TW after taking out it from the bisphosphonate solution. It is expected that apatite coated TW will contribute the hydrogel formation of molecules with phosphate groups.

収録刊行物

関連プロジェクト

もっと見る

キーワード

詳細情報 詳細情報について

問題の指摘

ページトップへ