Powder-based Additive Manufacturing for Development of Tailor-made Implants for Orthopedic Applications
-
- Nakano Takayoshi
- Division of Materials and Manufacturing Science, Graduate School of Engineering, Osaka University, Japan
-
- Ishimoto Takuya
- Division of Materials and Manufacturing Science, Graduate School of Engineering, Osaka University, Japan
この論文をさがす
抄録
Powder-based additive manufacturing (AM) technology has increasingly attracted attention because it realizes fabrication of arbitral three-dimensional structures with a great degree of freedom at high speed, which is almost impossible using conventional manufacturing tools. In early times, AM was known as a rapid prototyping (RP) which merely aimed at a trial prototyping of products mainly from resin materials. Today, thanks to the progress in the heat source, optical system, raw material production, etc., the expected role of AM has dramatically changed into a direct fabrication of final or near-final products made from a variety of materials from resins to ceramics, metals, and intermetallic compounds. Because the powder-based AM is a bottom-up manufacturing method, it offers a big advantage for the small-lot production of a wide range of products; therefore, tailor-made product portfolio is a potent target of AM. In this review paper, the advantage and possibility of AM in the development of functional metallic biomaterials for orthopedic usage is described. Medical treatments need to be flexibly done in accordance with individual pathological conditions and constitutions, therefore, the function of a medical device should be tunable, which is quite a strength of AM.
収録刊行物
-
- KONA Powder and Particle Journal
-
KONA Powder and Particle Journal 32 (0), 75-84, 2015
公益財団法人 ホソカワ粉体工学振興財団
- Tweet
詳細情報 詳細情報について
-
- CRID
- 1390282680489656576
-
- NII論文ID
- 130005004652
-
- NII書誌ID
- AA10690964
-
- ISSN
- 21875537
- 02884534
-
- NDL書誌ID
- 026022019
-
- 本文言語コード
- en
-
- データソース種別
-
- JaLC
- NDL
- Crossref
- CiNii Articles
- KAKEN
-
- 抄録ライセンスフラグ
- 使用可