書誌事項
- タイトル別名
-
- Study of roughness measurement of the square end mill processing side by an optical penetration type replica method
抄録
In this study, the replica of the metal processing surface was manufactured using the transparent silicone. Set for the new method for measurement using the transparence replica, it can get various characteristics by a processing method. The result was summarized in the following. The characteristic various patterns were provided by passing light in a transparence replica. Those patterns were able to be classified in a point pattern, a circle pattern, an oval pattern, four patterns of the diffraction pattern. It is possible that these patterns estimate the shape of the reflection plane, namely shape and processing method of the machined surface. The surface roughness by the diffraction was equal to the maximum height roughness by the tracer In the last paper, the empirical formula that showed the biggest height coarseness and the relations of the radius of gyration was provided in a circulation pattern and an oval pattern. This report makes a specimen of the end mill processing that is used a lot as a general processing method and shows the reliability as the measurement system of the assay by the transparence replica method.
収録刊行物
-
- 日本機械学会論文集
-
日本機械学会論文集 81 (821), 14-00204-14-00204, 2015
一般社団法人 日本機械学会
- Tweet
キーワード
詳細情報
-
- CRID
- 1390282680492574208
-
- NII論文ID
- 130005004998
-
- ISSN
- 21879761
-
- 本文言語コード
- ja
-
- データソース種別
-
- JaLC
- Crossref
- CiNii Articles
- KAKEN
-
- 抄録ライセンスフラグ
- 使用不可